Hot Tubs UK Chemicals and Accessories
Hot Tubs SPA POPPIT Sanitiser, Conditioner, Clarifier & Bactercide
START UP DIRECTIONS - for spas & hot tubs
FEATURES & BENEFITS:
* no chemical odours
* pleasant spa environment
* does not contain bromine
* suitable for asthmatics & those with chlorine sensitivity.
* simple to convert
* just follow these easy steps
Since dust, dirt and plastic residue can exist in your new spa following manufacture, we recommend you clean the spa prior to use.
USE INSTRUCTIONS - NEW SPA:
1. Fill spa with water to directed level.
2. Add 60gr of Poppit Quick Fix/per 1000 litres of water and filter for
4 hours. Do not add any other chemicals until the 4 hours of filtering
have been completed.
3. Check pH, alkalinity & calcium levels using Insta Test Strips (ph
should be 7.2 – 7.6 & alkalinity should be around 80-120ppm,)
if readings are low, use Poppit Water Balance to correct levels. If pH
readings are high use Poppit pH Reducer. Calcium levels should be 100
– 200ppm, if low these can be increased using Poppit Spa Cal Hardener.
4. Heat spa water to desired temperature. (26-36 degrees C)
5. Add 1 litre of Spa Poppit per 1000 litres of spa water
REGULAR MAINTENANCE OF SPAS & HOT TUBS
* To burn off organic matter (hair, skin, lotions, etc.) use 30grms
Poppit Quick Fix per 1000 litres of water and filter for 4 hours. Do not
add any other chemicals until the 4 hours of filtering have been completed.
* Check pH and alkalinity after using Poppit Quick Fix and adjust as required
using Poppit Water Balance or Poppit pH Reducer.
* Directly before using spa, (after water has been heated to desired temperature),
use the Poppit Test Kit to determine weather Spa Poppit is required. Half
fill the Poppit Test Kit vial or a glass with spa water and add 1 drop
of the test solution.
* If the drop turns brown, within a few seconds, the test is letting you
know that your spa has the correct level of Spa Poppit and is ready for
you to use.
* If the drop turns pink, Spa Poppit must be added.
* Add a minimum of 200ml of Spa Poppit per person for the first 1 to 2
people then for every extra person, add an extra 100ml of Spa Poppit per
1000 litre of spa water (ie. For a total of 3 people in a spa, add 500ml,
total of 4 people in spa, add 600ml and so on per 1000lt spa water).
* Remember to run filter for approximately 4 hour per day and after each
use.
* Clean filter cartridges every week using Poppit Filter Soak formulation.
Do not use cartridge cleaners which may contain chlorine.
* Prior to dumping water (usually every 6-8 weeks), clean pipes by adding
50 mls Poppits Spa Pipe Degreaser per 1000 litres of spa water running
blowers for 30-60 minutes
Or please contact the Spa World